ar6350p140002rg

Cut off rear fender

Type ar · topic 63.50 · version 0102 · 2018-09-14

Applies to: Model 190.3

Where it sits

Function group 3 Body › 63 Side wall › 63.50 Rear fenders — Series 190 (models 3**)

EinPAS 35 Body/frame/detachable parts › 35.34 Sidewall › 35.34.35 Fender/sidewall — Series 190 (models 3**)

EinPAS 35 Body/frame/detachable parts › 35.37 Fender › 35.37.31 Rear fender — Series 190 (models 3**)

AR63.50-P-1400-02RG

Cut off rear fender

Model

190.3

The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.

Cut off rear fender

P63.50-4054-08

1

Mark separating point on fender (1) according to picture and cut (area A).

Do not make the cuts too deep.
Otherwise the components below can be damaged and weakened.

Dimension:a = 54 mm
Dimension: b = 66 mm

Cut off rear fender

2

Expose weld seams on fender (1) and cut (areas B, C).


P63.50-4057-04

Cut off rear fender

P63.50-4055-08

3

Heat flow drill bolts on fender (1) and unscrew (area E).

Flow drill bolts are glued.

4

Expose self-piercing riveting on fender (1) and cut (areas D, F).

Cut off rear fender

P63.50-4056-08

5

Expose self-piercing riveting on fender (1) and cut (area G).

Cut off rear fender

P63.50-4058-08

6

Expose self-piercing riveting on fender (1) and cut (area H).

Cut off rear fender

P63.50-4059-08

7

Expose self-piercing riveting on fender (1) and cut (areas I, J, L).

Cut off rear fender

P63.50-4060-08

8

Expose self-piercing riveting on fender (1) and cut (area K).

Cut off rear fender

P63.50-4061-09

9

Heat fender (1) in crosshatched areas and remove.

Cross-hatched areas are bonded.

Cut off rear fender

10

Grind mating surfaces down to bare metal in the cross-hatched inner C-pillar sidewall .


Observe pretreatment of bonding surfaces.



11

Remove shavings.


P63.50-4062-06