ar6330d000802ts

Prepare complete sliding door entry

Typ ar · temat 63.30 · wersja 0100 · 2018-02-13

Dotyczy: Model 907.6/7 with code T16 (Sliding door right) Right side of vehicle Model 907.6/7 with code T19 (Sliding door left) Left side of vehicle

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.30 Podłużnica na zewnątrz — Seria 907 (modele 6**, 7**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.20 Kabina kierowcy/ karoseria › 35.20.50 Wejście — Seria 907 (modele 6**, 7**)

AR63.30-D-0008-02TS

Prepare complete sliding door entry

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Model

907.6/7

with code T16 (Sliding door right)

Right side of vehicle

Model

907.6/7

with code T19 (Sliding door left)

Left side of vehicle

Repair materials

Number

Designation

Order number

BR00.45-Z-1056-07A

1K-zinc dust paint

A 000 986 28 00

The next steps are shown on component parts on model 907.633 with code T16 (right sliding door) on the right side of the vehicle and must be carried out in the same way for vehicles with code T19 (left sliding door) on the left side of the vehicle in the event of damage.

Prepare complete sliding door entry

1

Punch holes in complete sliding door entrance section (1) with a diameter of 6 mm (areas B).



2

Drill holes in complete sliding door entrance section (1) with a diameter of 7 mm (areas A, B, and C).



3

Grind mating surfaces on complete sliding door entrance section (1) down to bare metal in cross-hatched areas and around holes (areas A, B, and C).


Sand down spot weld flanges to bare metal on both sides.



4

Remove shavings and drill chips.



5

Zinc dust paint to insides of spot weld flanges.


D63.30-0357-11

Prepare complete sliding door entry

6

Punch holes in complete sliding door entrance section (2) with a diameter of 6 mm (areas E and G).



7

Drill holes in complete sliding door entrance section (2) with a diameter of 7 mm (areas D and F).



8

Grind mating surfaces on complete sliding door entrance section (2) down to bare metal in cross-hatched areas and around holes (areas D, E, F, and G).


Sand down spot weld flanges to bare metal on both sides.



9

Remove shavings and drill chips.



10

Zinc dust paint to insides of spot weld flanges.


D63.30-0358-05

Prepare complete sliding door entry

D63.30-0359-09

11

Drill holes in complete sliding door entrance section (3) with a diameter of 7 mm (areas H, I, J, and K).

12

Grind mating surfaces on complete sliding door entrance section (3) down to bare metal in cross-hatched areas and around holes (areas H, I, J, and K).

Sand down spot weld flanges to bare metal on both sides.

13

Remove shavings and drill chips.

14

Zinc dust paint to insides of spot weld flanges.

Powiązane dokumenty