S62.20-A034-06
S60.00-A050-09
1 | Cable tie | 3 | Subharness | |
2 | Front door sealing frame | 4 | Floor covering |
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.Typ 447 mit Motor 780 | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment | Typ 447 mit Motor 780 | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Detach ground line of on-board electrical system battery. | ||
2 | Disconnect ground line of auxiliary battery. |
| |
3 | Remove ground line of the auxiliary battery for ECO start/stop function. |
| |
Model 447 with code D50 (Full-width partition wall) with code MJ8 (ECO start/stop function), model 447 with code D51 (Full-width partition wall with 1 window) with code MJ8 (ECO start/stop function), model 447 with code MJ8 (ECO start/stop function) with code S23 (Two-seater front passenger seat) | |||
4 | Disconnect ground on additional battery for park pawl emergency shift. |
| |
5 | Remove fender liner in the front fender. | ||
6 | Remove front-end assembly. | ||
7 | Remove front fender. | ||
8 | Remove door sill. | ||
9 | Remove front door sealing frame (2). | ||
10 | Place floor covering (4) to one side away from repair area. | ||
11 | Remove cable ties (1). | Installation: Replace cable ties (1). | |
12 | Place subharness (3) to one side. | ||
13.1 | Remove HV battery module. | * Applies to Europe only | |
Model 447 with engine 780.701 | |||
13.2 | Remove high-voltage battery | * Applies to Europe only | |
Model 447 with engine 780.702 | |||
14.1 | Remove engine with transmission. | Model 447 with engine 622, 651, 654.9, model 447, 448 with engine 274 | |
Model 447 with engine 651 | |||
Model 447 with engine 654.9 | |||
Model 447 with engine 622.9 | |||
Model 447, 448 with engine 274 | |||
Model 447 with engine 622.8 | |||
14.2 | Remove axle drive module of front axle with tubular frame. | Model 447 with engine 780 | |
Model 447 with engine 780.701 | |||
Model 447 with engine 780.702 | |||
15 | Remove refrigerant lines of rear air conditioning system at underbody in working area. | Model 447.8 with engine 780.702 with code HZ7 (Semiautomatically controlled air conditioning system, TEMPMATIC in rear) | |
For this purpose, open respective brackets. | |||
16 | Install in the reverse order. |
Powiązane dokumenty
- ah0000z030001a Ogólne wskazówki dotyczące pojazdów z instalacją wysokiego napięcia i/lub akumulatorem litowo-jonowym i/lub gazowym systemem napędu oraz osobistego wyposażenia ochronnego
- ah6800n000101s Wskazówki dotyczące wykonywania prac naprawczych we wnętrzu pojazdu
- ar0110s2401e
- ar0110s2401ea
- ar0110s2401ef
- ar0110s2401eg
- ar0110s2401eg
- ar0110s2401eh
- ar0810s0008f
- ar0810s0008g
- ar4770s0001f
- ar4770s0002g
- ar5410s0003e
- ar5410s0003e
- ar5410s0004e
- ar5410s0111e
- ar5410s0111ee
- ar5410s0120e
- ar6000s0023e
- ar6830s4100e
- ar7210s2120e
- ar8810s1000e
- ar8810s1300e
- as0000z001001a Zagrożenie życia na skutek ześlizgnięcia lub spadnięcia pojazdu z podnośnika.
- as0000z003501a Zagrożenie życia podczas prac przy elementach i systemach U >=30 V napięcie zmienne (AC) bądź U >=60 V napięcie zmienne