ar3530p062002v

Extract/press in rear axle shaft from rear axle differential

Typ ar · temat 35.30 · wersja 0101 · 2011-02-01

Dotyczy: MODEL 171, 172

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 35 Oś tylna › 35.30 Napęd, wały napędowe — Seria 171 · Seria 172

EinPAS 17 Zespół przeniesienia napędu/ oś › 17.51 Oś tylna › 17.51.51 Półoś/ wałek napędowy — Seria 171 · Seria 172

AR35.30-P-0620-02V

Extract/press in rear axle shaft from rear axle differential

Extract/press in rear axle shaft from rear axle differential

P35.30-2020-01

Extraction

1 Use a suitable tool (e.g. assembly lever) to pry rear axle shaft (37) on the joint ring (37c) far enough out of rear axle differential until the rear axle shaft (37) is noticeably disengaged.

2 Pull rear axle shaft (37) out of rear axle center assembly

When pulling out the rear axle shaft (37), do not damage the radial sealing ring in the rear axle center assembly. Rear axle shafts (37) with defective joints or boots must be replaced.

Extract/press in rear axle shaft from rear axle differential

P35.30-2021-01

Pressing in

3 Press rear axle shaft into rear axle differential until the retaining ring (37g) noticeably engages.

Position joint ring horizontally so that the splined profile is not tilted when inserted. When pressing the rear axle shaft into the rear axle center assembly, do not damage the radial sealing ring. The joint ring must close flush with the rear axle housing.