Niedostępne w języku „pl”; wyświetlono w języku Angielski.
Umiejscowienie
Grupa funkcyjna 2 Podwozie › 35 Oś tylna › 35.30 Napęd, wały napędowe — Seria 909
EinPAS 17 Zespół przeniesienia napędu/ oś › 17.51 Oś tylna › 17.51.65 Przekładnia osi tylnej/ napęd przelotowy osi — Seria 909
Dotyczy też silników/skrzyń biegów: 741 130, 741 408
AR35.30-D-4670-03R
Install joint flange at drive pinion
Rear axle
741.130/408 in model 909
Test and adjustment values for rear axle drive
Number
Designation
Rear axle 741.40/43
Rear axle 741.1
BE35.30-N-1001-01B
Friction torque of drive pinion bearing
with radial shaft sealing ring
Nm
2,5...3
2,5...3
without radial shaft sealing ring
Nm
1,65...3,74
1,65...3,74
001 589 49 21 00
Torque meter
717 589 00 31 00
Retainer wrench
1
Mount joint flange on the drive pinion.
If present the groove on the drive pinion and groove on the joint flange must match.
2
Attach retainer wrench (01) to joint flange.
D35.25-0005-01
3
Screw on new collar nut and tighten in stages carefully until the specified total friction moment (friction torque) is reached.
4
Detach retainer wrench (01) from joint flange.
5
Use the torque meter (02) to check the total friction moment on the drive pinion.
6
Carefully tighten collar nut further in stages until the specified total friction moment is reached.
Never correct total friction coefficient by slackening collar nut. Avoid tightening the collar nut too tightly. Otherwise the inner compressed ring will be pushed together whereupon it must then be replaced. This requires complete dismantling of the gear set.
Check total friction moment after each retightening using the torque meter (02).
