AR18.30-P-6840FG | Remove/install oil-water heat exchanger | 20.9.04 |
ENGINE 639.939 in MODEL 454.0## 1# with CODE (LHD) Left-hand drive vehicle
P18.30-2082-06
1 Oil/water heat exchanger
2 Oil filter
3 Coolant hose
4 Bolts
| Remove/Install | ||
Danger! | Risk of injury to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage bottles. Wear protective gloves, protective clothing and eye protection. | |
Danger! | Risk of death cased by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. | |
1 | Raise vehicle. | ||
2 | Unscrew oil filter (2) | Collect oil which flows out in a suitable vessel. | |
Installation: Replace the oil filter (2) and cover the oil filter seal (2) with engine oil. | |||
| |||
3 | Unclamp coolant hoses (3) using appropriate hose clamps and dismantle at oil-water heat exchanger (1) | Collect coolant which flows out in a suitable vessel. | |
4 | Remove bolts (4) | | |
5 | Remove oil-water heat exchanger (1) | Installation: replace seal for oil-water heat exchanger (1). | |
6 | Install in the reverse order | ||
7 | Check engine oil level by means of oil dipstick | Fill level must lie between the markings, 'Min' and 'Max'; otherwise, engine damage may occur. Let engine run for approx. 1 minute, then switch off and wait approx. 5 minutes. Test fill level again and correct if required. | |
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns when working in engine during starting procedure | Secure vehicle to prevent it from moving. | |
8 | Perform engine test run and check for leaks at oil water heat exchanger (1) | ||
9 | Check coolant level, adjust to correct level if necessary. | ||
| Engine cooling system - inspect fluid level, adjust to correct level. Inspect anticorrosion/ antifreeze protection, adjust to correct concentration |
Oil filter
Oil-water heat exchanger
Powiązane dokumenty
- ap2000p2010fg
- as0000z000501a Niebezpieczeństwo wypadku na skutek samoczynnego ruszenia przy pracującym silniku. Niebezpieczeństwo obrażeń na skutek zmiażdżenia lub poparzenia przy wykonywaniu czynności podczas rozruchu lub przy pracującym silniku.
- as0000z001001a Zagrożenie życia na skutek ześlizgnięcia lub spadnięcia pojazdu z podnośnika.
- as2000z000101a Niebezpieczeństwo zranienia skóry i oczu przez poparzenie wytryskującym, gorącympłynem chłodzącym. Niebezpieczeństwo zatrucia na skutek połknięcia płynu chłodzącego