ar1820s3471a

Removing and installing oil filter housing

Typ ar · temat 18.20 · wersja 0103 · 1999-09-07

Dotyczy: ENGINE 601 in MODEL 638

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 1 Silnik › 18 Układ smarowania silnika, układ chłodzenia oleju › 18.20 Filtr oleju — Seria 601 · Seria 638

EinPAS 15 Silnik › 15.20 Układ smarowania silnika › 15.20.31 Filtr/chłodzenie/termostat/wentylator/zbiornik — Seria 601 · Seria 638

AR18.20-S-3471A

Removing and installing oil filter housing

4.5.95

ENGINE 601 in MODEL 638

Removing and installing oil filter housing

S18.20-2000-06

1 Screw with inside hexagon (M8x40)

2 Screw with inside hexagon (M8x110)

3 Support

4 Oil filter casing

5 Oil filter

6 Support

7 Gasket

8 Adjustment bushings

9 Oil-water heat interchanger

10 Set of starter cables

11 Fuel pipes

B11 Oil pressure sensor

Removing and installing

1

Remove the oil filter

Let the oil come out of the oil filter casing

AP18.00-D-0101A

2

Remove and separate the oil-water heat interchanger (9) from the oil filter casing (4) together with the attached coolant pipes.

Do not drain the coolant.
Collect the spilt oil.
Replace the stopper retainers.

AR18.30-S-6840B

3

Remove the oil pressure sensor (B11)

AR18.40-S-4132B

4

Open the clips and cable-bearer (arrows) in support (5 and 3). Separate the fuel pipes (11) and the set of starter cables (10)

Installation: The clips must click in

5

Remove the oil filter casing (4)


Collect the spilt oil
Pay attention to the adjustment bushings (8)

*BA18.20-N-1002-01A

Installation: Clean the contact surfaces
Replace the gasket (7)
Pay attention to the assembly position of the support (3)

6

Installation in reverse order

Oil filter

Number

Name

Engine 601.942
601.970

BA18.20-N-1002-01A

Oil filter casing in the engine block

Nm

21

Powiązane dokumenty