1 | Electrical wiring harness |
2 | Clip |
3 | Screw/bolt |
4 | Screw/bolt |
5 | Clamp |
6 | Engine cover |
G3/2x1 | Electrical connection for oxygen sensor upstream of catalytic converter |
S01.10-4592-05
| Remove/install | ||
1 | Remove engine charge air duct upstream of charge air cooler | ||
2 | Remove electrical wiring harness (1) | To do this remove clips (2) and take electrical wiring harness (1) out of guide. | |
Installation: Check clips (2), replace if necessary. | |||
3 | Remove electrical connection for oxygen sensor upstream of CAT (G3/2x1) from engine cover (6) | ||
4 | Remove screw/bolt (3) | ||
5 | Remove screw/bolts (4) | ||
6 | Open clamps (5) | ||
7 | Remove engine cover (6) | Installation: Check for correct seating of the engine cover (6). | |
8 | Install in the reverse order |