Remove/install radar sensor with bracket

AR30.30-B-1200A

Remove/install radar sensor with bracket

09.02.2018

Engine

457.9, 460.9 in model 634.011/012/061/071/081

with code BC6 (Advanced emergency braking system - AEBS)

with code ET7 (Lane Assistant - LDWS)

Engine

926.9 in model 382.177

1

Mounting bracket

2

Bolts

3

Electrical connector

4

Radar sensor

5

Digital goniometer



Remove

1

Open the engine front compartment

2

Detach the electrical plug (2) from the radar sensor (4)

 The plug is placed on the driver side.

3

Remove the screw (2) from the mounting bracket (1)



Install

4

Tighten the screw (2) on mounting bracket (1)

 The torque of the screws may vary according to the bodybuilder.

5

Insert the electrical plug (3) in the radar sensor (4)

 The radar sensor must be mounted with the connector facing the left side of the vehicle in the direction of travel.

6

Adjust the radar sensor (4)

AR30.30-B-1001A

7

Close the engine front compartment

8

Connect the diagnostic equipment

9

Calibrate the radar sensor (4)

AR54.21-B-3003-02A

 At the end of the calibration, perform a key cycle (KL15), and only switch off the vehicle after 15 seconds.

10

Remove the diagnostic equipment