1 | Mounting bracket |
2 | Bolts |
3 | Electrical connector |
4 | Radar sensor |
5 | Digital goniometer |
B30.30-0006-06
| Remove | ||
1 | Open the engine front compartment | ||
2 | Detach the electrical plug (2) from the radar sensor (4) | The plug is placed on the driver side. | |
3 | Remove the screw (2) from the mounting bracket (1) | ||
| Install | ||
4 | Tighten the screw (2) on mounting bracket (1) | The torque of the screws may vary according to the bodybuilder. | |
5 | Insert the electrical plug (3) in the radar sensor (4) | The radar sensor must be mounted with the connector facing the left side of the vehicle in the direction of travel. | |
6 | Adjust the radar sensor (4) | ||
7 | Close the engine front compartment | ||
8 | Connect the diagnostic equipment | ||
9 | Calibrate the radar sensor (4) | ||
At the end of the calibration, perform a key cycle (KL15), and only switch off the vehicle after 15 seconds. | |||
10 | Remove the diagnostic equipment |
Referenced documents
- ar3030b1001a Adjust radar sensor
- ar5421b300302a Calibrate radar sensor