S35.31-A000-09
Shown on model 447.813 except code RR6 (Spare wheel with jack) |
1 | Rear axle gear | 4 | Electric parking brake control unit | 7 | Bolts | ||
2 | Brake cable | 5 | Electrical connector | 8 | Vent line | ||
3 | Bolts | 6 | Front mount |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Raise vehicle. | ||
2 | Remove spare wheel. | Model 447 with engine 274, 651, 654.9 | |
3 | Remove lower underfloor paneling. |
| |
4 | Remove a rear axle shaft. | ||
5 | Remove brake cables (2) from holders. | Model 447.8 with engine 274, 651, 654.9 | |
6 | Remove bolts (3) and place electric parking brake control unit (4) to one side. | Model 447.8 with engine 274, 651, 654.9 | |
M6 | |||
7 | Disconnect electrical connector (5) and remove electrical wiring harness from electric parking brake control unit (4). | Model 447.8 with engine 274, 651, 654.9 | |
8 | Remove propeller shaft with flex disk from rear axle differential (1) and fasten outside the working area. | ||
9 | Support rear axle differential (1). | ||
| 000 588 11 62 00 Major assembly mount | ||
| 000 588 10 62 00 Support plate | ||
10.1 | Remove front support (6). | If rear axle differential (1) is replaced. | |
10.2 | Remove front support (6) from underbody. | If rear axle differential (1) is used again. | |
11 | Remove bolts (7) and remove rear axle differential (1). | Screw/bolt, rear suspension of rear axle differential to rear axle differential | |
12 | Lower rear axle differential (1). | Lower rear axle differential (1) far enough until bleed line (8) is accessible. | |
13 | Remove bleed line (8) from feed-through grommet and route through body opening. | Installation: Ensure correct installation position. | |
14 | Remove remaining rear axle shaft from rear axle differential (1) and fasten to underbody. | | |
Depending on the version of the rear axle shaft, apply an assembly lever at a suitable position. Helper required. | |||
Installation: Retaining ring must engage noticeably on the rear axle differential (1). | |||
15 | Check snap ring of rear axle shaft for damage. | Depending on the findings, | |
| |||
replace snap ring. | |||
16 | Remove rear axle differential (1). | ||
17 | Replace radial shaft sealing rings of rear axle differential (1). | ||
18 | Install in the reverse order | ||
| Check | ||
19 | Check/correct oil level in rear axle differential (1). | ||
|
Viitatut asiakirjat
- ah0000p002001a Kääntökulmaohjatulla kiristysmenetelmällä valmistettuja ruuviliitoksia koskevia ohjeita
- ah5400p000101a Ohjeita elektronisten rakenneosien sähköstaattisen varauksen purkautumisen aiheuttamien vaurioiden välttämiseksi
- ap3500s3501e Taka-akseli - öljynvaihto
- ar0060s1000e
- ar3510s2490e
- ar3530s0620e
- ar3531s0545e
- ar4110s0050e
- ar6130s100103e
- as0000z001001a Hengenvaara: Auto saattaa pudota tai kipata nosturilta
- as0040z000101a Loukkaantumisvaara: Varo, ettei vaihteistoöljyä pääse iholle tai silmiin. Vaihteistoöljyn nieleminen on terveydelle vaarallista
- ws0100p0092b
- ws2600p3309b