Central locking control with remote control key, function

P80.20-2042-09

Operating the CL using the transmitter key

Function shown on model 220

A2/12 Rear window antenna amplifier module

A8/1 Transmitter key

A26/1 Left front IR receiver

A26/2 Right front IR receiver

A37 PSE control module (combined function)

CAN Controller area network

E1e5 Left front turn signal lamp

E2e5 Right front turn signal lamp

P1 Pneumatic actuator, driver's door

P2 Pneumatic actuator, front passenger's door

P3 Pneumatic actuator, left rear door (on model 220 only)

P4 Pneumatic actuator, right rear door (on model 220 only)

P6 Pneumatic actuator, tank flap

S Actuation of turn signal lamps via the corresponding control modules

E3e1 Left rear turn signal lamp

E4e1 Right rear turn signal lamp

E6/5 Left exterior mirror turn signal lamp

E6/6 Right exterior mirror turn signal lamp

N10/8 Rear SAM control module

N69/1 Left front door control module

N69/2 Right front door control module

N70 Overhead control panel control module

N73 EIS control module

N80 Steering column module

The vehicle can be locked and unlocked with the remote control key. There are two operating modes for the "Unlocking" function:
"Universal unlocking" and "Selective unlocking". In the "Universal unlocking" mode all doors, the tank flap and the trunk lid are unlocked. In the "Selective unlocking" mode only the driver's door and the tank flap are unlocked. In both operating modes the anti-theft alarm (ATA) is deactivated.
The "Unlocking" function can be triggered by pressing the "Unlock" button on the remote control key. The remote control key can be set in such a manner that the first actuation is either "universal" or "selective".

The turn signal lamps flash once to indicate successful unlocking.
If the "Unlock" button is pressed again on the remote control key following "selective unlocking" the vehicle is unlocked "universally".

The "Locking" function can be started by pressing the "Lock" button on the remote control key. All locking points are locked and the ATA is activated. The turn signal lamps flash three times to indicate successful locking.