AR83.60-D-7215A | Remove/install additional heat exchanger | 28.6.11 |
MODEL 900, 906.6 /7 with CODE (H13) Additional heat exchanger in load compartment
D83.30-1201-08
1 Plug of electric connection line
2 Seals
4 Additional heat exchanger
3 Coolant hoses
| Remove/install | ||
Danger! | Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. | |
| Notes on coolant | ||
1 | Lift/jack up vehicle | ||
2 | Pinch off coolant hoses (3) | Clamping device | |
3 | Detach coolant hoses (3) from additional heat exchanger (4) | Collect escaping coolant in a clean vessel. | |
4 | Detach electrical connection line plug (1) from connecting cable of additional heat exchanger (4) | ||
5 | Remove additional heat exchanger (4) from underbody | Installation: Check condition of seals (2) for ducts to the interior compartment, replace if necessary. | |
6 | Install in the reverse order | ||
7 | Adjust coolant to correct level |
Circuit
000 589 54 37 00
Referenced documents
- ah2000n208001a Notes on coolant
- ap2000d2010h Engine cooling system - check fluid level, adjust to correct level. Inspect anticorrosion/antifreeze protection, adjust to correct concentration
- ar0060d1000h Lift/jack up vehicle
- as2000z000101a Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant.