1 | Battery management system control unit |
2 | Seat base cover |
3 | Mounting clip |
4 | Electrical connector |
D47.70-A001-76
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | ||
Topical note | Notes on carrying out repair work in the vehicle interior | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
2.1 | Remove driver seat. | Model 910 except code SR8 (Driver's seat bogie) | |
2.2 | Remove turn plate with installed driver's seat. | Model 910 with code SR8 (Driver's seat bogie) | |
Do not separate driver's seat from turn plate. | |||
3 | Remove seat base cover (2). | ||
4 | Remove nuts of retaining clips (3). | The retaining clips (3) are destroyed in this process. | |
Installation: Attach new retaining clips (3) to battery management system control unit (1) and press battery management system control unit (1) onto threaded pins. The retaining clips (3) latch into place while doing so. | |||
5 | Remove battery management system control unit (1). | For this purpose, disconnect electrical connector (4). | |
6 | Install in the reverse order. | ||
7 | Carry out commissioning of battery management system control unit (1) using diagnostic system. | When replacing battery management system control unit (1). | |
| Connect/disconnect diagnostic unit |
Referenced documents
- ad0000d200006ts Connect/disconnect diagnostic unit
- ah0000z030001a General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment
- ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
- ah6800n000101s Notes on carrying out repair work in the vehicle interior
- ar9110d1000ts Remove/install front seat
- ar9110d1456ts Remove/install front seat turntable
- as0000z003501a Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)