Applies to: Model 374 Model 375.30/32/35/37 Model 375.4 Model 930.0/1/2, 932.0/1/2, 933.1, 934 Model 940, 942.1, 943.1, 944 Model 950.0/1/2/5/6, 952.0/1/2/5/6, 953.1/6, 954
Model 950.0/1/2/3, 952.0/1/2/3, 953.1/3, 954.0/1/2
BA46.40-N-1006-06P
Clamp to drag link
M10x1
Nm
50
50
M12x1.5
Nm
80
80
M14x1.5
Nm
170
170
625 589 00 35 00
Puller
1
Remove cover (4).
If present.
W46.40-1071-01
2.1
Nut (6) on underside of steering arm (7). Left-hand drive vehicle Turn steering to left until nut (6) can be unscrewed from steering arm (7).
2.2
Nut (6) on underside of steering arm (7). Right-hand drive vehicle Turn steering to right until nut (6) can be unscrewed from steering arm (7).
W46.40-1072-01
3
Unfasten clamp (8).
W46.40-1075-01
W46.40-1076-01
4
Unscrew nut (6) from steering arm (7) and screw on again by hand.
Screw in nut (6) up to safety collar. This prevents the thread of the ball joint on the drag link (1) from being damaged during removal.
Counterhold the ball joint with an Allen wrench if necessary.
5
Pry drag link (1) off steering arm (7) with puller.
The drag link (1) detaches suddenly.
W46.40-1073-01
W46.40-1074-01
6
Set steering gear to center position.
7
Unscrew nut (6) and remove drag link (1) from steering arm (7).
8
Set front axle to straight ahead position by adjusting drag link (1).
To do so, screw ball joint into the drag link (1) or unscrew it from the drag link (1), insert drag link (1) into steering arm (7) and check whether the front axle is in the straight-ahead position following the adjustment. Repeat procedure until the front axle is in the straight-ahead position. Make sure that the steering gear is still in the center position.
9
Install new nut (6) and tighten .
Counterhold the ball joint with an Allen wrench if necessary.
