Remove/install front axle half

AR33.10-D-0200TSF

Remove/install front axle half

22.11.2019

Model

910

Modification notes

12.07.2019

Document reference added

Operation steps 1, 8

1

Front-axle half

2

Nut

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

Topical note

Notes on threaded connections fastened using a tightening angle-based tightening process

AH00.00-P-0020-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

Notes on repair work on suspension components

AH00.00-P-0100-01A

 

Remove/install

1

Loosen respective front axle shaft.

Model 910 with engine 651

AR33.30-D-6530TSF

 Removal: To do so, only loosen screw of wheel hub at front axle shaft and reapply.

* Applies to Europe only



Remove/install left front axle shaft
Model 910 with engine 780.703

AR33.30-D-0621TE

Remove/install right front axle shaft
Model 910 with engine 780.703

AR33.30-D-0622TE

2

Remove brake disk.

AR42.10-D-0230TS

3

Remove rpm sensor from steering knuckle.

AR42.40-D-9801TS

4

Remove existing electrical wiring harnesses from suspension strut.

5

Remove torsion bar linkage from suspension strut.

AR32.35-D-3330TS

6

Remove ball head of tie rod from steering knuckle.

AR46.40-D-7242TS

7

Remove supporting joint from steering knuckle.

AR33.20-D-0460TS

8

Remove screw of wheel hub at front axle shaft.

Model 910 with engine 651

AR33.30-D-6530TSF

 Installation: Screw in (but do not yet tighten) new screw on wheel hub at front axle shaft.

* Applies to Europe only



Remove/install left front axle shaft
Model 910 with engine 780.703

AR33.30-D-0621TE

Remove/install right front axle shaft
Model 910 with engine 780.703

AR33.30-D-0622TE

9

Lower vehicle.

10

Remove front-axle half (1).

 To do so, detach nut (2) and remove front-axle half (1) downward.
Aid of helper required.

 Installation: Replace nut (2).

 Nut, suspension strut to mounting support

*BA32.25-N-1001-04TSF

 Socket wrench

*907589000900

11

Install in the reverse order.

 Suspension struts

Number

Designation

Model 910

BA32.25-N-1001-04TSF

Nut, suspension strut to mounting support

Nm

170