1 | Sealing ring |
2 | Transmission |
3 | Screw |
4 | Electrical connector |
L8 | Transmission rpm sensor |
S26.19-4503-06
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | ||
| Remove/install | ||
1 | Open engine hood and secure against falling down | ||
2 | Perform power disconnect on high voltage system | ||
3 | Disconnect electrical connection (4) | ||
4 | Unscrew bolt (3) | Installation: Replace screw/bolt(3). | |
5 | Pull rpm sensor for transmission (L8) out of transmission (2) | Installation: Install new sealing ring (1). | |
6 | Clean opening in transmission (2) using clean rags | ||
7 | Install in the reverse order |
Referenced documents
- ah0000z030001a General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment
- ar5410s1160ev Disable/enable high-voltage system
- as0000z003501a Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)