P20.10-2211-09
1 Poly-V-belt
2, 3 Pulley
6 Coolant hose
4 Retaining clamp
5 Coolant pump
| Remove/install | ||
1 | Switch off ignition | ||
2 | Drain coolant from radiator | ||
3 | Remove poly-V belt (1) | ||
4 | Remove guide pulleys (2, 3) | ||
5 | Pry off the retaining clamp (4) of the electrical feed line from the coolant pump (5) | ||
6 | Dismount coolant hose (6) from coolant pump (5) | Installation: Replace sealing ring on coolant hose (6). | |
7 | Remove bolts and coolant pump (5) from timing case cover | Installation: Replace gasket and note bolting plan. | |
| Clean | ||
8 | Clean the sealing surfaces on the coolant pump (5) and the timing case cover with a rag | ||
9 | Install in the reverse order | ||
10 | Inspect cooling system for leaks | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the running engine | Secure vehicle to prevent it from moving by itself. | |
11 | Conduct engine test run and check coolant pump (5) for leaks |
Referenced documents
- ar1321p3350rx Remove/install poly-V belt guide pulley
- ar1322p1202rx Remove, install poly V-belt
- ar2000p1010rx Inspect cooling system for leaks
- ar2000p1142rx Drain/pour in coolant
- ar2000p1142rx
- ar2010p127103va Bolt plan for coolant pump
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.