ar2000p0001g

Remove/install engine block heater

Type ar · topic 20.00 · version 0105 · 2012-02-21

Applies to: ENGINE 612.965 in MODEL 463.322 /323 with CODE (HP1) Cooling package ENGINE 612.966 in MODEL 461.302 /331 /332 /342 /345 with CODE (HP1) Cooling package

Where it sits

Function group 1 Engine › 20 Engine cooling system › 20.00 General — Series 461 (models 302, 331, 332, 342, 345) · Series 463 (models 322, 323)

EinPAS 15 Engine › 15.25 Engine cooling system › 15.25.30 Pump/thermostat/preheater — Series 461 (models 302, 331, 332, 342, 345) · Series 463 (models 322, 323)

Also applies to engines/gearboxes: 612 965, 612 966

AR20.00-P-0001G

Remove/install engine block heater

15.2.12

ENGINE 612.965 in MODEL 463.322 /323 with CODE (HP1) Cooling package

ENGINE 612.966 in MODEL 461.302 /331 /332 /342 /345 with CODE (HP1) Cooling package

Remove/install engine block heater

P20.00-2130-09

1 Connector

2 Retaining spring

3 Cap

6 Clip

7 Bracket

8 Engine block heater

4 Electrical line for engine block heater

5 Cable tie

Remove/install engine block heater

P20.00-2249-11

9 Connector

Remove/install

Danger!

Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant.

Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.

Wear protective gloves, protective clothing and safety glasses.

AS20.00-Z-0001-01A

Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

1

Activate Service mode in Tele-Aid emergency call system

Only on model 463.322/323 with Tele-Aid car phone emergency call system ET2.

AR82.95-P-0005-03GR

Notes regarding the Tele-Aid emergency call system

Model 463.243/244/245/247/248/250/ 254/270/309/322/323/332/333 TELE AID car telephone emergency call system ET2

AH82.95-P-0001-01GA

2

Disconnect ground cable from battery

Model 463.322/323

AR54.10-P-0003G

Model 461.302/331/332/342/345

AR54.10-P-0003GL

Notes on battery

All models

AH54.10-P-0001-01A

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

3

Lift/jack up vehicle

AR00.60-P-1000G

4

Remove underride guard

5

Reduce pressure in cooling system

To do this, turn radiator cap to first detent then close again.

6

Drain coolant

Replace coolant

AP20.00-P-2080G

Notes on coolant

All engines

AH20.00-N-2080-01A

7

Remove heater unit

Model 461.302/332/342/345, 463.322/323 with auxiliary heater, code H12

AR83.70-P-5302GL

Model 461.331

AR83.70-P-5302GLC

8

Remove charge air manifold

AR09.41-P-1310GS

9.1

Unhinge plug (1) at retaining spring (2) and detach cap (3)

Only for model 461.302/332/342/345, 463.322/323

9.2

Detach connector (9) at brush guard

Only on model 461.331

10

Slacken electrical line of engine block heater (4)

For this step disconnect cable tie (5) and remove clamp (6) from bracket (7)

Installation: Replace cable ties (5).

11

Remove engine block heater (8)

Installation: Install new O-ring.

*BA20.00-P-1001-01B

*119589000300

General information on coolant preheater

AH20.00-P-1001-01A

12

Install in the reverse order

13

Fill and bleed steering system

AR46.20-P-0500-10F

*BF46.20-P-1001-01B

14

Bleed cooling system

Model 461.302/331/332/342/345

AR20.00-P-1142-06GL

Model 463.322/323

AR20.00-P-1142-06GI

15

Inspect cooling system for leaks

Cooling and heating system - check condition of radiator, lines and hoses

AP20.00-P-2050G

16

Deactivate service mode in TELE AID emergency call system

Only on model 463.322/323 with Tele-Aid car phone emergency call system ET2.

AR82.95-P-0005-03GR

Notes regarding the Tele-Aid emergency call system

Model 463.243/244/245/247/248/250/ 254/270/309/322/323/332/333 TELE AID car telephone emergency call system ET2

AH82.95-P-0001-01GA

17

Read out fault memory and erase

STAR DIAGNOSIS
Stored faults which can result from lines being disconnected or from simulation during removal and installation or test work, have to be processed and erased in the fault memories after completing the work

Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

STAR DIAGNOSIS diagnosis system, Compact Passenger Car 6511 1801 00

Coolant preheater

Number

Designation

Engine 611, 612, 613

BA20.00-P-1001-01B

Coolant preheater in engine block

Nm

35

Filling quantities for steering gear

Number

Designation

Model
461, 463

BF46.20-P-1001-01B

Power steering

Filling capacity

Liters

1.0

MB steering gear oil

Sheet

BB00.40-P-0231-01A

Remove/install engine block heater

Box wrench bit

119 589 00 03 00

Referenced documents