AR18.40-D-5111A | Remove/install oil level sensor | 4.12.09 |
ENGINES 611.981 /987 in MODEL 901.6, 902.6, 903.6, 904.6
ENGINES 612.981 in MODEL 902.6, 903.6, 904.6, 905.6
ENGINES 611.983 in MODEL 690.6
D18.40-0004-06
1 Oil level sensor
2 Sealing ring
3 Connector
4 Screw
5 Bow
6 Screw
7 Front anti-roll bar
| Remove/install | ||
1 | Drain engine oil, pour in | ||
| Engine oil and filter change | ||
2 | Detach anti-roll bar (7) at front axle and turn down | Installation: Replace self-locking nut. | |
| |||
3 | Unplug connector (3) at oil level sensor (1) | ||
4 | Remove oil level sensor (1) | Installation: Replace seal ring (2) and grease on installation. The oil level sensor is to be pressed in before the threaded connection against the resistance of the O ring all the way into the opening of the oil pan in order to prevent tipping of the O ring. | |
| |||
5 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
6 | Inspect for oil leaks | Run engine until warm, switch off and inspect for leaks. |
Oil level/oil pressure sensor
Front axle stabilizer
Number | Designation | Models 690, 901, 902, 903, 904 | Model 905 | ||
BA32.35-N-1001-02E | Bolt or nut, anti-roll bar bearing shell to front axle beam | M8 | Nm | 30 | 30 |
Repair materials
Number | Designation | Order number |
BR00.45-Z-1001-06A | Long-life grease | A 000 989 63 51 11 |
Referenced documents
- ap1800d0101a Engine oil and oil filter change
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.