1 | Engine cover |
2a | Engine cover |
2b | Engine cover |
3a | Engine air intake duct |
3b | Engine air intake duct |
4a | Engine compartment cover |
4b | Engine compartment cover |
4c | Engine compartment cover |
4d | Engine compartment cover |
P01.00-3421-06
6 | Seal |
B6/4 | Left intake camshaft Hall sensor |
B6/5 | Right intake camshaft Hall sensor |
B6/6 | Left exhaust camshaft Hall sensor |
B6/7 | Right exhaust camshaft Hall sensor |
P15.10-2478-06
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1.1 | Remove the respective engine cover (2a, 2b) | When removing intake camshaft Hall sensors (B6/4, B6/5) | |
1.2 | Remove respective engine air intake duct (3a, 3b) | When removing exhaust camshaft Hall sensors (B6/6, B6/7) | |
2 | Disconnect electrical connection from the respective camshaft Hall sensor (B6/4, B6/5, B6/6, B6/7) | ||
3 | Remove screw/bolt and pull respective camshaft Hall sensor (B6/4, B6/5, B6/6, B6/7) out of the cylinder head cover | Installation: Replace sealing ring (6). | |
Bolt, camshaft Hall sensor to cylinder head cover | |||
4 | Install in the reverse order | ||
5 | Read out fault memory using the diagnostic system and clear if necessary | ||
| |||
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
6 | Carry out an engine test run, checking the engine for proper operation and leaktightness |
Referenced documents
- ad0000p200004b Connect STAR DIAGNOSIS and read out fault memory
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.