Crank engine with starter · ar0110p0110rt · Mercedes-Benz WIS

AR01.10-P-0110RT

Crank engine with starter

15.11.2019

Engine	113.971 in model 251.075/175
	*

01	Compression recorder
01a	Contact switch
8	Ignition key

P01.10-2720-06

 	Remove/install
 Danger	Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)	Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.	AS00.00-Z-0035-01A
 Warning	Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.	Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
 Warning	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
1	Switch off ignition; detach ignition key (transmitter key)	 On vehicles with Keyless-Go, code 889: Press keyless go start/stop button repeatedly until ignition is switched off.
		 Remove transmitter key from vehicle and store it at a location beyond its transmission range (at least 2 m).
2	Open hood		AR88.40-P-1000RT
3	Remove partition wall between wheel wells		AR62.30-P-2400RT
4	Connect up compression recorder (01)		AR01.10-P-0010-01GZ
		 Electrical connection kit	*220589009900
		 Compression tester	*001589762100
5	Crank engine with starter	 Turn engine by pressing the contact switch (01a) on the compression recorder (01).
6	Install in the reverse order
7	Read out fault memory and clear if necessary
			AD00.00-P-2000-04A
		 If the ignition was switched on during the process.
		 Stored faults entries which may have been caused by disconnecting lines or by a simulation must be erased in the fault memory after completing the work.

220 589 00 99 00

Electrical connection kit

001 589 76 21 00

Compression tester

Referenced documents

ad0000p200004a
ad0000p200004a Connect STAR DIAGNOSIS and read out fault memory
ar0110p001001gz Connect compression recorder
ar6230p2400rt Remove/install partition wall between wheelhouses
ar8840p1000rt Opening engine hood, moving to upright position and closing
as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.
as0000z003501a Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)