P91.60-2492-06
Shown on passenger-side frontal acceleration sensor, model 211.070
1 Bolts
2 Air intake hose
3 Electrical connector
B48/1 Driver-side frontal acceleration sensor
B48/2 Passenger-side frontal acceleration sensor
M13 Coolant circulation pump
Modification notes
| Remove/Install | ||
| Notes on avoiding damage to electronic components due to electrostatic discharge | ||
1 | Ignition Off, detach transmitter key from the electronic ignition switch control unit | On vehicles with code (889) Keyless go: Press keyless go start/stop button repeatedly until the ignition is switched off. Remove the transmitter key from the vehicle and store it in a location beyond its transmission range (min. 2 m). | |
2 | Open engine hood | See Operating Instructions | |
3 | Remove air intake hose (2) | ||
4.1 | Disconnect electrical connector from coolant circulation pump (M13) | Only when removing passenger-side frontal acceleration sensor (B48/2). | |
5.1 | Loosen coolant circulation pump (M13) with rubber retainer from bracket and tie to one side | Only when removing passenger-side frontal acceleration sensor (B48/2). | |
6 | Remove bolts (1) | | |
7 | Take out driver-side (B48/1) or front passenger-side (B48/2) frontal acceleration sensor | Installation: The arrow on the driver-side frontal acceleration sensor (B48/1) has to point into the direction of travel. The arrow on the passenger-side frontal acceleration sensor (B48/2) has to point opposite to the direction of travel. | |
8 | Disconnect electrical connector (3) on the driver-side frontal acceleration sensor (B48/1) or passenger-side frontal acceleration sensor (B48/2) | ||
9 | Install in the reverse order |
Airbag
Henviste dokumenter
- ah5400p000101a Oplysninger med henblik på at undgå skader på elektroniske komponenter på grund af elektrostatisk afladning