AR83.70-W-5302D | Remove/install heater unit | 21.10.97 |
MODELS 950, 952, 953, 954 with BODY 942.899
with CODE (H60) Warm air heater "Eberspächer D1 LP"
with CODE (H62) Warm air heater "Eberspächer D3 LP"
W83.70-0136-09
1 Sound deadener
2 Hexagon nut
3 Exhaust pipe
4 Fuel pipe
8 Intermediate rings
9 Muffler
10 Hexagon nut
5 Tie strap
6 Rubber grommet
7 Exhaust
W83.70-0137-09
4 Fuel pipe
11 Connector
14 Hose clamp
12 Hexagon bolt
13 Heater unit
| Removal/installation | ||
Danger! | Risk of injury from being pinched and squeezed when tilting cab | Do not enter the tilting radius of the cab when tilting forwards and back, and screen off danger area to prevent unauthorized access. Always tilt the cab to the end position. | |
| Notes on tilting the cab | ||
1 | Disconnect ground lead from battery | Do not interrupt main battery current in heater mode or in the run-on phase. | |
2 | Tilt cab | ||
3 | Remove water shield | Only for code (F04) cab L (long) | |
4 | Remove storage compartment | Only for code (F04) cab L (long) | |
5 | Remove sound deadener (1) | ||
6 | Cut cable straps (5) | ||
Danger! | Risk of explosion caused by fuel vapors igniting, risk of poisoning caused by inhaling combustible gases and risk of injury caused by burns during and after operation of heater unit | Do not operate stationary heater, auxiliary heater or engine with heater booster in closed areas or when refueling. Allow heater unit to cool down after operation and wear protective gloves. | |
7 | Detach muffler (9) | Installation: Tighten hex nut (2) on exhaust pipe for final time. | |
8 | Detach exhaust pipe (3) | Installation: Position exhaust pipe and just bolt on hex nut (2) loosely to begin with. | |
9 | Lower cab | ||
10 | Separate electrical connector (11) on heater | ||
11 | Fold back left floor mat and unscrew hex bolts (12) at flange of heater | | |
12 | Lift heater upward until Phillips screw on hose clamp (14) becomes accessible | Installation: Replace sealing profile. | |
13 | Remove hose clamp (14) and pull out fuel line (4) downward | ||
14 | Install in the reverse order |
Stationary heater unit
Number | Designation | Models | Models | ||
BA83.70-N-1004-03A | Nut of exhaust pipe flange to cab rear wall | Nm | 8 | 8 | |
BA83.70-N-1005-03A | Bolt of heater to cab floor | Nm | 20 | 20 | |
BA83.70-N-1021-03A | Nut of heater to cab floor | Nm | 20 | 20 | |
Henviste dokumenter
- ah6080n000301a Oplysninger om tipning af førerhus
- ar6130w0010a
- ar8860w3171a
- as6080z000101a Fare for personskade ved fastklemning og knusning, når førerhuset tippes
- as8370z000201a Fare for eksplosion på grund af brændstofdampe, fare for forgiftning ved indånding af forbrændingsgas og fare for personskade på grund af forbrændinger, under eller efter at varmesystemet har været i drift.