AR67.10-D-1000-06A | Cut out windshield with cutting wire | ||
| Cover panel for protecting the rubber seal on the instrument panel |
D67.10-0032-01
1 Position suction cups.
Suction lifting device
gotis://K_67.0_03.0
2 Cut cutting wire to approx. 0.5 m and guide along position "A" with needle-nosed pliers from inside of vehicle through window seal toward outside.
Glass removal device
gotis://K_67.0_01.0
In order to avoid damaging paint, mask the windshield cutout at the A-pillar with masking tape beforehand.
D67.10-0027-01
3 Attach the counterholder (7) from the window separating kit to the end of the cutting wire in the interior of the vehicle.
Glass removal device
gotis://K_67.0_01.0
4 Attach the T-handle section (8) from the window separating kit to the other end of the cutting wire.
Glass removal device
gotis://K_67.0_01.0
D67.10-0028-01
5.1 Support counterholder (7) at top and sides approx. 30 cm above wire passage on adhesive bead, pull outer T-handle (8) in direction of counterholder (7) and cut adhesive bead.
5.2 Lay wire around corner and pull handle/counterholder alternately so that the adhesive bead is sawed and not cut.
5.3 Saw in lower center area as described in 5.2 because adhesive bead is overlapped here at the factory and cannot be cut easily.
D67.10-0037-01
Hold shop-made cover panel (10) between window flange and seal (11) in area of instrument cover (9) and do not damage seal (11) when cutting out window.
Maintain tension in the cutting wire throughout the entire glass removal procedure, as the wire otherwise breaks as a result of kink formation.
6 Remove windshield from window opening with suction cups.
Suction lifting device
gotis://K_67.0_03.0