The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.
1 | Mark separating points on rear fender (1) and cut (areas A and B). |
Transfer separation points from vehicle. |
P63.50-4091-05
2 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Grind mating surfaces down to bare metal on inside (area D). |
Sand down spot weld flanges to bare metal on both sides. |
3 | Remove grinding dust and drill chips. |
4 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (areas C and D). |
Observe pretreatment of bonding surfaces. |
P63.50-4092-05
5 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
6 | Remove grinding dust and drill chips. |
7 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (areas E). |
Observe pretreatment of bonding surfaces. |
P63.50-4093-06