ar5410d1127ts

Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle

Type ar · emne 54.10 · version 0101 · 2020-01-10

Gælder for: Model 907, 910

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 54 El-system, udrustning og instrumenter › 54.10 Batteri, spændingsforsyning, spændingstransformer — Serie 907 · Serie 910

EinPAS 25 bilens ledningsnet/netværk/multifunktion › 25.20 Køretøjets ledningsnet › 25.20.1 Grundinformation — Serie 907 · Serie 910

AR54.10-D-1127TS

Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle

09.01.2020

Model

907, 910

Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle

D54.10-1225-79

Shown on model 907 with engine 651.9

1

Jump-start connection point

4

Ground terminal

2

Cover

5

Ground connection

3

Positive terminal

Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle

D54.10-1226-79

Shown on model 910 with engine 651.9

1

Jump-start connection point

4

Ground terminal

2

Cover

5

Ground connection

3

Positive terminal

Danger

Risk of fire/risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death due to voltage U >= 30 V AC and U >= 60 V DC.

No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

Topical note

Notes on battery

AH54.10-P-0001-01A

Preservation of on-board electrical system voltage

1

Open hood.


The procedure for maintaining the on-board electrical system voltage must not be carried out when working on the restraint system, when welding or when working on lines without contact protection.
Otherwise, the electrical system or electronic component parts may be damaged.

2

Slide back cover (2) and clip positive terminal (3) of charger onto jump-start connection point (1).

000 588 00 81 00 Charger

WS54.00-P-0037B


Do not reverse polarity.
Damage caused by short circuits will otherwise occur.

Observe symbols on cover (2).

3

Clip ground clamp (4) of charger onto ground connection (5).

4

Switch on charger.

5

Switch off charger after completing check and diagnosis work on the vehicle.

6

Disconnect ground clamp (4) of charger from ground connection (5).

7

Disconnect positive terminal (3) of charger from jump-start connection point (1).

8

Close hood.

Henviste dokumenter