1 | Steering column trim upper part, top |
2 | Steering column trim lower part, top |
3 | Plastic frame |
4 | Bellows |
5 | Latch rings |
6 | Compressed air lines |
7 | Steering column bracket |
8 | Retaining bolt |
9 | Lock washer |
10 | Valve |
W46.15-1006-05
| Remove/install | ||
1 | Position steering column to lowest position | ||
2 | Release compressed air from auxiliary consumer circuit | ||
3 | Detach upper part of upper steering column trim (1) from lower part of upper steering column trim (2) and swivel downward to instrument cluster | ||
4 | Remove key | ||
5 | Remove lower part of the upper steering column trim (2) from the steering column bracket (7) | ||
6 | Remove plastic frame (3) and take off lower part of upper steering column trim (2) | There are six plastic clamps on the plastic frame (3), with which the boot (4) is fastened to the lower part of the upper steering column trim (2). | |
7 | Detach compressed air lines (6) from valve (10) | To do so, push latch ring (5) for each compressed air line (6) onto valve (10), hold it in this position and disconnect the respective compressed air line (6). | |
8 | Remove circlip (9) | Installation: Replace circlip (9). | |
9 | Pull retaining bolt (8) out of valve (10) and remove valve (10) | ||
10 | Install in the reverse order |