P07.04-2495-06
1 Water hose
2 Thermostat housing
3 Venting hose
4 Shield
5 Bracket
6 Wiring harness
B4/6 Rail pressure sensor
B11/4 Coolant temperature sensor
| Remove/install | ||
Danger! | Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. | |
1 | Drain coolant | ||
2 | Remove engine cover | ||
3 | Disconnect electrical connector on coolant temperature sensor (B11/4) | ||
4 | Disconnect water hose (1) from thermostat housing (2) | Installation: Check hose clamp for damage; replace if necessary. | |
5 | Disconnect vent hose (3) from thermostat housing (2) | Installation: Check hose clamp for damage; replace if necessary. | |
6 | Remove shield (4) | | |
7 | Unplug electrical plug connector at rail pressure sensor (B4/6) | ||
8 | Remove bracket (5) | ||
9 | Remove thermostat housing (2) | In order to better reach the bolts on the thermostat housing (2), unhook the wiring harness (6). | |
Installation: Replace seal on thermostat housing (2). | |||
| |||
| |||
10 | Install in the reverse order | ||
11 | Inspect cooling system for leaks |
Common rail diesel injection (CDI)
Number | Designation | Engine | ||
BA07.16-P-1008-01D | Shield to thermostat, water pump and cylinder head cover | M6 | Nm | 14 |
Coolant pump, coolant thermostat
Henviste dokumenter
- ar2000p1010cw
- ar2000p1142cw
- as2000z000101a Risiko for skoldningsskader på hud og øjne pga. sprøjtende, varm kølervæske. Risiko for forgiftning ved indtagelse af kølervæske