Shown on Engine 651, type 205, without code ME04 (mild hybrid drive) |
1 | Electrical connector |
2 | Clip |
3 | Engine air intake duct downstream of air filter housing |
4 | Air cleaner housing |
5 | Electrical connector |
6, 7 | Electrical wiring harness |
8 | Bolts |
N3/9 | CDI control unit |
P09.10-2313-06
P09.10-2314-08
9 | Elastomer bearing | B2/5 | Hot film mass air flow sensor |
| Remove/install | ||
1 | Remove upper engine cover | ||
2 | Remove engine air intake duct upstream of the air filter housing (4) | ||
3 | Release and disconnect electrical connection (1) | ||
4 | Loosen clamp (2) | ||
5 | Detach engine air intake duct downstream of air filter housing (3) from air filter housing (4) | ||
6 | Unclip electrical connection (5) from bracket and place to one side | ||
7 | Unclip electrical wiring harnesses (6, 7) on air filter housing (4) | Engine 651 in model 205 (except 205.012/212), 253 | |
8.1 | Detach CDI control unit (N3/9) at air filter housing (4) and place to one side with attached electrical lines | Engine 651 in model 205 (except 205.012/212), 253 | |
8.2 | Detach CDI control unit (N3/9) at air filter housing (4) and place to one side with attached electrical lines | Engine 651 in model 205.012/212 | |
9 | Click air filter housing (4) at the front upwards out of brackets, pull forwards out of rear bracket and remove air filter housing (4) | | |
10 | Check elastomer bearing (9) for damage and replace if necessary | ||
11 | Install in the reverse order |