P07.08-2124-06
1 Cover
2 Electrical connector
3 Electrical connector
4 Retaining lug
5 Retaining frame
N3/9 CDI control unit
| Remove/install | ||
| Information on preventing damage to electronic components due to electrostatic discharge | ||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | |
1 | Read out coding of CDI control unit (N3/9) | Only when replacing CDI control unit (N3/9) and if it can be read out using STAR DIAGNOSIS. | |
| Connect STAR DIAGNOSIS and read out fault memory | ||
2 | Unclip cover (1) | Do not damage retaining lug at the cover (1). | |
3 | Disconnect electrical connectors (2, 3) at CDI control unit (N3/9) | To disconnect electrical connectors at CDI control unit (N3/9), pull the locks to the outside. | |
Installation: Check that the wiring harness gasket is at the correct position. | |||
4 | Release retaining lugs (4) and remove CDI control unit (N3/9) from retaining frame (5) | Installation: Ensure correct seating in retaining frame. | |
5 | Install in the reverse order | ||
6 | Encode CDI control unit (N3/9) | Only if a new CDI control unit (N3/9) is installed. | |
| Connect STAR DIAGNOSIS and read out fault memory |
Henviste dokumenter
- ad0000p200004a
- ad0000p200004a
- ah5400p000101a Oplysninger med henblik på at undgå skader på elektroniske komponenter på grund af elektrostatisk afladning
- ar8810p1300rt
- as0000z001101a Fare for personskade pga. fastklemning eller knusning af fingre ved af-, påmontering og indstillingsarbejde på motorhjelm og bagklap, døre, dæksler og soltag.