Remove/install intake camshaft adjustment solenoid

AR05.20-P-7305MRT

Remove/install intake camshaft adjustment solenoid

10.12.2018

Engine

256.9 in model 222

1

Electrical connector

3

Bolts

Y49/1

Intake camshaft solenoid

 Caution

Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil

Wear protective gloves, protective clothing and safety glasses.
Do not fill engine oil into beverage containers.

AS18.00-Z-0001-01A

Topical note

Notes on threaded connections with aluminum screws/bolts

AH00.00-P-0006-01RM

Topical note

Notes on avoiding damage through contamination and foreign objects

AH00.00-P-5000-01A

Topical note

Notes on threaded connections fastened using a tightening angle-based tightening process

AH00.00-P-0020-01A

 

Remove/install

1

Remove engine air intake duct downstream of air filter.

AR09.10-P-8130MRT

 Installation: Only install upper engine cover after the leak test.

2

Unscrew the screw of bracket 48 V wiring harness on the cylinder head and place the 48 V wiring harness to one side.

 Bolt, holder/cable duct for 48 V subharness to rear cap on cylinder head/charge air cooler/engine carrier/timing case cover

*BA15.18-P-1001-03MRT

3

Release electrical connector (1) and disconnect.

4

Unscrew the screws (3) and remove solenoid of intake camshaft (Y49/1).

 Installation: Replace screws/bolts (3).

 Bolt, camshaft solenoid to timing case cover

*BA15.10-P-1003-03I

5

Install in the reverse order.



Check

6

Read out and delete fault memory.



AD00.00-P-2000-04B

 Warning

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

7

Carry out engine test run and check engine for proper leaktightness and leaktightness.

8

Install upper engine cover.

AR01.10-P-2405MRT

 Position sensor

Number

Designation

Engine 256.9

BA15.10-P-1003-03I

Bolt, camshaft solenoid to timing case cover

Stage 1

Nm

4

Stage 2

°

60

 48 V on-board electrical system subharness

Number

Designation

Engine 256 in model 222

BA15.18-P-1001-03MRT

Bolt, holder/cable duct for 48 V subharness to rear cap on cylinder head/charge air cooler/engine carrier/timing case cover

Nm

8