Remove/install drive plate

AR03.30-D-8003TSC

Remove/install drive plate

25.01.2019

Engine

274 in model 907

1

Washer

2

Bolts

3

Drive plate

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Notes on avoiding damage through contamination and foreign objects

AH00.00-P-5000-01A

Topical note

Notes on threaded connections fastened using a tightening angle-based tightening process

AH00.00-P-0020-01A

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

 

Remove/install

1

Remove transmission with torque converter.

AR27.10-D-0500TSC

2

Insert retaining lock in starter opening and engage in starter ring gear.

 Turn engine in direction of engine rotation if necessary.

 Retaining lock

*112589034000

 Socket wrench bit

*001589650900

3

Unscrew bolts (2).


Do not use air-powered tools to unscrew and screw in the screws (2).
The thread in the crankshaft flange can be damaged otherwise.

 Installation: Replace screw/bolts (2).
Tighten screws (2) evenly in a crosswise pattern.

 Bolt, drive plate to crankshaft

*BA03.30-N-1003-01CA

4

Remove washer (1).

 Installation: The cylinder pin for the crankshaft determines the installation position of the disk (1).

5

Remove drive plate (3).

 Installation: The cylinder pin for the crankshaft determines the installation position of the drive plate (3).



Check

6

Check ring gear and thread of drive plate (3) for damage.

If the ring gear or a thread is damaged:



Replace drive plate (3).

7

Check end cover and radial shaft sealing ring for leaks.

If necessary,



Remove crankshaft pulse ring.

AR15.12-D-0001TSC

If a leakage is present,



replace cap with radial shaft sealing ring.

AR01.40-D-8925TSC

8

Install in the reverse order

 Belt pulley, flywheel, drive plate

Number

Designation

Engine 274 in model 907

BA03.30-N-1003-01CA

Bolt, drive plate to crankshaft

Stage 1

Nm

45

Stage 2

°

90