1 | Flywheel |
2 | Bolts |
3 | Guide bearing |
4 | Retaining lock |
D03.30-1136-06
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | ||
Topical note | Notes on evaluating two-mass flywheels | ||
| Remove/install | ||
1 | Remove clutch. | ||
2 | Remove starter. | ||
3 | Insert retaining lock (4) in starter opening of the timing case cover. | Retaining lock | |
4 | Remove screws (2). | Installation: Replace screw/bolts (2). | |
Bolt, two-mass flywheel to crankshaft | |||
5 | Remove retaining lock (4) from starter opening of the timing case cover. | Retaining lock | |
6 | Remove flywheel (1). | Installation: The retaining pin of the crankshaft must engage in the mounting hole of the flywheel (1). | |
| Clean | ||
7 | Clean flywheel (1). | Cold degreasing agent/cold cleaning solvent HAKU 1025-920 | |
| Check | ||
8 | Check flywheel (1). | WIS Service Media | |
Depending on the findings, | |||
| |||
replace flywheel (1). | |||
9 | Check rear radial shaft sealing ring for leak tightness. | If a leak is present, | |
| |||
Replace rear radial shaft sealing ring. | |||
10 | Install in the reverse order |
651 589 02 40 00
Retaining lock
Henviste dokumenter
- ah0000p002001a Oplysninger om skrueforbindelser, som er fremstillet efter den drejevinkelstyrede tilspændingsmetode
- ah0330n100002a Oplysninger om bedømmelse af todelte svinghjul
- ar0320d3003tsr
- ar0320d3003tsr
- ar1530d7100tsr
- ar2510d0050ts
- as0000z001001a Livsfare, hvis køretøjet glider ned fra eller tipper på liften.