ar0140d920101a

Chamfer cylinder bores

Type ar · emne 01.40 · version 0105 · 2004-04-01

Gælder for: ENGINE 601.943, 602.980 /982 /984 /985

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 01 Motor komplet, motorudluftning, topstykke, motorblok › 01.40 Motorblok, takthusdæksel, endedæksel — Serie 601 (modeller 943) · Serie 602 (modeller 980, 982, 984, 985)

EinPAS 15 Motor › 15.15 forbrændingsmotor komplet/motorblok/krumtapdrev › 15.15.31 motorblok/olieudskiller/udluftning — Serie 601 (modeller 943) · Serie 602 (modeller 980, 982, 984, 985)

AR01.40-D-9201-01A

Chamfer cylinder bores

Inspection data for crankcase

Number

Designation

Engine
601.943

BE01.40-N-1006-02D

Chamfer of cylinder bore at contact surface of crankcase

mm

0.6-175°

BE01.40-N-1011-02D

Chamfer of cylinder bore at bottom cylinder runout

mm

1.520°

Inspection data for crankcase

Number

Designation

Engines
602.980/982/
983/984/985

BE01.40-N-1006-02D

Chamfer of cylinder bore at contact surface of crankcase

mm

0.2-175°

BE01.40-N-1011-02D

Chamfer of cylinder bore at bottom cylinder runout

mm

1.520°

Chamfer cylinder bores

P01.40-0229-01

1 After boring or face-grinding, chamfer cylinder bores with a suitable tool (e.g. hand milling tool) as shown on the drawing.

2 Equalize bottom edge of chamfer with a polishing stone.

Chamfer cylinder bores

P01.40-0300-01

Chamfer cylinder bores

D01.40-0056-01

3 Also deburr the lower cylinder outlet in the tilting range of the piston using a fine grinding stone if the cylinder barrel was machined.