D01.20-1041-08
Shown on ENGINE 642.898 in MODEL 906 |
1 | Oil separator | 3 | Sealing ring | 5 | Vent hose | ||
2 | Screw/bolts | 4 | Radial shaft sealing ring | 6 | Clamp |
| Remove/install | ||
1 | Remove trim panel to right cylinder head cover | ||
2 | Disconnect electrical connection from vent line heater element | ||
3 | Remove screw/bolts (2) | Screw/bolt, oil separator to cylinder head | |
4 | Remove oil separator (1) and vent hose (5) from cylinder head | ||
5 | Clean sealing surfaces on oil separator (1) and cylinder head and replace sealing ring (3) | ||
6 | Check radial shaft sealing ring (4) | If damage is present | |
| |||
Replace radial shaft sealing ring (4) | |||
7 | Unfasten clamp (6) and disconnect vent hose (5) from oil separator (1) | When replacing the oil separator (1) | |
8 | Check clamp (6) | When replacing the oil separator (1) | |
If damage is present | |||
| |||
Replace clamp (6) | |||
9 | Install in the reverse order | ||
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
10 | Perform engine test run and check engine around oil separator (1) for leaktightness |
Henviste dokumenter
- ar0120d5015sf
- as0000z000501a Fare for ulykke ved automatisk igangsætning når motoren kører. Fare for personskade på grund af knusning og forbrænding, hvis der arbejdes mens motoren startes eller kører