ap7240m7250a

Door and reversing system - function test

Type ap · emne 72.40 · version 0102 · 2005-09-29

Gælder for: MODEL 904.663 Sprinter Classic minibus, outward swinging door, 1-wing, door width 720 mm MODEL 904.663 Sprinter Classic minibus, outward swinging door, 1-wing, door width 850 mm MODEL 904.663 Sprinter Classic minibus, outward swinging door, 2-wing, door width 1350 mm MODEL 904.663 Sprinter Tourist minibus, outward swinging door, 1-wing, door width 850 mm MODEL 905.613 Sprinter Classic 6 t minibus, outward swinging door, 1-wing, door width 850 mm MODEL 905.613 Sprinter Classic 6 t minibus, out

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 72 Døre › 72.40 Dørstyring — Serie 904 (modeller 663) · Serie 905 (modeller 613)

EinPAS 35 Karrosseri/ramme/monteringsdele › 35.35 Dør › 35.35.30 Dørmotorsystem/dørstyring — Serie 904 (modeller 663) · Serie 905 (modeller 613)

AP72.40-M-7250A

Door and reversing system - function test

1.7.04

MODEL 904.663
Sprinter Classic minibus,
outward swinging door, 1-wing, door width 720 mm

MODEL 904.663
Sprinter Classic minibus,
outward swinging door, 1-wing, door width 850 mm

MODEL 904.663
Sprinter Classic minibus,
outward swinging door, 2-wing, door width 1350 mm

MODEL 904.663
Sprinter Tourist minibus,
outward swinging door, 1-wing, door width 850 mm

MODEL 905.613
Sprinter Classic 6 t minibus,
outward swinging door, 1-wing, door width 850 mm

MODEL 905.613
Sprinter Classic 6 t minibus,
outward swinging door, 2-wing, door width 1350 mm

MODEL 905.613
Sprinter Low-Floor 6 t minibus,
outward swinging door, 2-wing, door width 1350 mm,
outward swinging door, 1-wing, door width 850 mm, additionally behind rear axle

MODEL 905.613
Sprinter Classic 2+2 - 6.34 t minibus,
outward swinging door, 1-wing, door width 850 mm

Door and reversing system - function test
Door and reversing system - function test

M72.25-0006-02

Shown on outward swinging door,
1-wing, door width 850 mm

1 Exterior emergency unlocking handle

2 Door

3 Passenger door pushbutton switch

M72.25-0005-02

Door and reversing system - function test
Door and reversing system - function test

M72.25-0002-02

4 Interior emergency unlocking handle

5 Door knob

M72.25-0001-02

Check operation of door

Danger!

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

AS00.00-Z-0011-01A

1

Unlock door (2) at exterior emergency unlocking handle (1) and open and close door by hand

See Operator's Manual

2

Open and close door (2) by pressing passenger door pushbutton switch (3)

The indicator lamp in the passenger door pushbutton switch (3) must light up and go out again.

3

Open and close door (2) using remote control

See Operator's Manual

Check emergency unlocking

4

Remove lead seal from interior emergency unlocking handle (4)

5

Unlock door (2) at interior emergency unlocking handle (4)

6

Unlock lift/lock mechanism by turning door knob (5)

Only with outward swinging door, 1-wing, door width 850 mm.

7

Open and close door (2) by hand

8

Push back interior emergency unlocking handle (4)

9

Open and close door (2) by pressing passenger door pushbutton switch (3)

10

Attach new lead seal to interior emergency unlocking handle (4)

Check door reversing system

11

Open door (2) by pressing passenger door pushbutton switch (3), close again and hold test piece at middle of door between door (2) and door frame while door is closing

The door (2) must open again, if necessary:

with outward swinging door, 1-wing, with pressure wave door reversal

Adjust swiveling door reversing system
- subject to separate repair order.

AR72.25-M-1000-02B

except with outward swinging door, 1-wing, with pressure wave door reversal

Install new door control unit
- subject to separate repair order.

Test piece for door reversing system

WF58.50-M-7240-01A

12

Open door (2) by pressing passenger door pushbutton switch (3), close again and hold test piece approx. 150 mm above door bottom edge between door (2) and door frame while door is closing

The door (2) must open again, if necessary:

with outward swinging door, 1-wing, with pressure wave door reversal

Adjust swiveling door reversing system
- subject to separate repair order.

AR72.25-M-1000-02B

except with outward swinging door, 1-wing, with pressure wave door reversal

Install new door control unit
- subject to separate repair order.

Test piece for door reversing system

WF58.50-M-7240-01A

13

Close door (2) by pressing passenger door pushbutton switch (3)

The indicator lamp in the passenger door pushbutton switch (3) must go out.

Check automatic locking

14

Switch on automatic locking while vehicle is in motion

See Operator's Manual

15

Press passenger door pushbutton switch (3) during road test

The door (2) should not open when the vehicle is moving at a speed of 3 km/h and higher.

Henviste dokumenter