03-8001 Removing and installing flywheel or driven plate
Preceding work: Manual or automatic transmission removed (26-1200 or 27-2010). Clutch removed (25-1000). |
1 | Oil sump |
2 | Straight pin |
3 | Flywheel |
4 | Twelve-sided stretch bolt check, 35 Nm + 90 ° |
5 | Driven plate (automatic transmission) |
6 | Flywheel (automatic transmission) |
Flywheel with manual transmission
Engine OM 601/602
Flywheel with automatic transmission
Engine OM 601/602
Note
New flywheels may be installed without static or dynamic balancing.
Special tool
Removing, installing
-------------------------------
1 Install engine lock (7) into the oil sump (1).
601 589 02 40 00
2 Unscrew twelve-sided stretch bolts (4).
Installation note
Screw twelve-sided stretch bolts tight,
35 Nm + 90 ° angle of rotation.
Note
As the twelve-sided stretch bolts are subject to a permanent stretch after tightening, they must be replaced if the maximum length of L=22.5 mm is exceeded.
3 Take off flywheel (3).
Installation note
Ensure the straight pin (2) is correctly seated.
4 Vehicles with automatic transmission:
Take off flywheel (6) and driven plate (5).
Installation note
Ensure the straight pin (2) is correctly seated.
5 Install in the reverse order.