AR83.70-D-5744A | Remove/install combination sensor for overheating/flame | 24.11.02 |
MODELS 901.62#, 902.62#, 903.62#, 904.62#, 905.62# ## as of 382002 as of 12.3.02 with CODE (H11) Warm air auxiliary heater
AIRTRONIC heater D2
MODELS 901.66# /67#, 902.66# /67#, 903.66# /67#, 904.66# ## as of 382002 as of 12.3.02 with CODE (H11) Warm air auxiliary heater
AIRTRONIC heater D4
MODELS WD1##, WD2##, WD3##, WD6##, WD7## ### as of 382002 as of 12.3.02 with CODE (H11) Warm air auxiliary heater
AIRTRONIC heater D4
D83.70-1287-09
1 Cover
2 Casing housing
3 Locking lug
7 Auxiliary heating control unit
8 Combination sensor plug connection line
9 Combination sensor connection line
4 Locking clamp
5 Combination sensor for overheating/flame
6 Heat exchanger
| Remove/Install | ||
1 | Remove heater | Models 901.6, 902.6, 903.6, 904.6, 905.6 with AIRTRONIC heater D2 | |
Models 901.6, 902.6, 903.6, 904.6, WD1, WD2, WD3, WD6, WD7 with AIRTRONIC heater D4 | |||
2.1 | Remove heater from the housing | Models 901.6, 902.6, 903.6, 904.6, WD1, WD2, WD3, WD6, WD7 with AIRTRONIC heater D4 | |
3 | Unlock locking lugs (3) of cover (1) | ||
4 | Lift up cover (1) and remove from casing housing (2) of the heater | ||
5 | Remove auxiliary heater control unit (7) | Only remove control unit, do not disconnect cables | |
6 | Disconnect plug (8) of connection lines for combination sensor from auxiliary heater control unit (7) | ||
7 | Release locking clamp (4) | Installation: Route connection lines (9) of combination sensor through the hoop eye of the locking hoop (arrow). | |
8 | Remove combination sensor (5) from heat exchanger (6) | Installation: Push combination sensor up to the stop under the casing housing. Check installation position of combination sensor. The combination sensor must make flat contact with the heat exchanger, if necessary correct the position of the sensor. | |
9 | Install in the reverse order |