Remove and install evaporator temperature sensor

AR83.30-D-8085A

9.2.01

MODELS 901.6, 902.6, 903.6, 904.6, 905.6 with CODE (HH9) Automatic air conditioning "Tempmatic"

Remove and install evaporator temperature sensor

D83.30-1110-11

1 Connector

2 Evaporator temperature sensor

 	Removing, installing
1	Disconnect ground cable of battery
2.1	Remove cover of the radio installation shaft	with code ER0, preparation for radio installation  Unclip electrical leads from the cover
2.2	Remove radio	with code EF5, EF6 and EF7, Radio Sound 10, 20 or 30	AR82.60-D-7502A
3	Remove glove compartment
4.1	Remove stowage compartment beneath pen holder	except code J19, tachograph
4.2	Remove tachograph	with code J19, tachograph	AR54.30-D-0001A
5	Remove cover on instrument cluster		AR68.10-D-1550A
6	Remove instrument cluster		AR54.30-D-6015C
7.1	Remove stowage compartment above the glove compartment	except code SA6, front passenger airbag	AR68.10-D-1515A
7.2	Remove front passenger airbag	with code SA6, passenger airbag	AR91.60-D-0680B
8	Remove cover above air vent on passenger side	with code SA6, passenger airbag	AR68.10-D-1090A
9	Remove loud speaker		AR82.62-D-7833A
10	Remove cover on center part of instrument panel		AR68.10-D-1190A
11	Remove air conditioning pushbutton control module		AR83.25-D-1124A
12	Remove drawer		AR68.10-D-1195A
13	Remove upper section of instrument panel		AR68.10-D-1020B
14	Remove electrical center		AR54.25-D-1382A
15	Remove air vents in instrument panel		AR68.10-D-1110A
16	Remove instrument panel		AR68.10-D-1000A
17	Disconnect plug (1) from evaporator temperature sensor (2)
18	Remove evaporator temperature sensor (2) from heater housing
19	Install in the reverse order
20	Set time at instrument cluster	except code J19, tachograph
21	Set time at the timer for auxiliary coolant heater	with H12, hot water auxiliary coolant heater or code H86, timer for auxiliary coolant heater
22	Code radio if necessary
23	Read out fault memory	 Erase DTC memory if applicable

Odkazované dokumenty