AR68.10-P-1502MCC | Remove/install bottom paneling for dashboard on passenger side | 21.7.11 |
MODEL 451.3 /4
P68.10-3760-09
1 Passenger side paneling
2 Lower section of dashboard
3 Wiring harness
4 Knee protection
X39/45 External audio source separation point
(with code (41Z) AUX jack)
5 Expansion clip
6 Screw
7 Cross member below dashboard
P68.10-3759-06
7 Cross member below dashboard
N4 Communication control unit
(if retrofitted)
P68.10-3761-07
1 Passenger side paneling
8 Clamping ring
X39/45 External audio source separation point
(with code (41Z) AUX jack)
9 Expander
10 Sheet metal nut
| Remove/install | ||
1.1 | Remove radio | On vehicles with code (C50) smart radio 10 or with code (C57) smart radio 9 or with code (527) Radio High-Line or with code (P02) car2go. | |
1.2 | Remove center stowage compartment. | On vehicles without code (C50) smart radio 10 or without code (C57) smart radio 9 or without code (527) Radio High-Line or without code (P02) car2go. | |
2 | Remove dashboard lower section (2) | ||
3 | Remove right side paneling from dashboard | ||
4 | Unclip right knee guard (4) (arrow A), loosen from guides (arrows B) and remove. | Installation: Route wiring harness (3) on upper control panel control unit in recess specified. | |
5 | Disconnect wiring harness of external audio source separation point (X39/45) on communication control unit (N4) (arrow C) | On vehicles with code (41Z) AUX jack and code (C47) Bluetooth or code (19Z) Portable navigation unit | |
The communication control unit (N4) is fastened to the crossmember below in the dashboard (7). | |||
6 | Open lid on glove box | On vehicles with code (I63) Glove box | |
7 | Remove expansion clips (5) on passenger-side paneling (1) | ||
8 | Close glove box lid | On vehicles with code (I63) Glove box | |
9 | Unscrew bolts (6) on passenger-side paneling (1) | Rechargeable drill / screwdriver gotis://G_58.0_01.1 | |
10 | Remove passenger-side paneling (1) | On vehicles with code (41Z) AUX jack, observe installation position of wiring harness on external audio source separation point (X39/45) | |
11 | Remove glove box | On vehicles with code (I63) Glove box | |
12 | Unclip expander (9) of external audio source separation point (X39/45) from clamping ring (8) with a suitable screwdriver | When replacing passenger-side paneling (1) on vehicles with code (41Z) AUX jack. | |
13 | Press clamping ring (8) together and push out external audio source separation point (X39/45) toward the rear and out of passenger-side paneling (1) | When replacing passenger-side paneling (1) on vehicles with code (41Z) AUX jack. | |
14 | Remove sheet metal nut (arrow D) and sheet metal nut (10) from passenger-side paneling (1) | When replacing passenger-side paneling (1). | |
15 | Install in the reverse order |