ar4310p0355va

Remove/install brake booster vacuum line

Typ ar · téma 43.10 · verze 0200 · 2010-11-02

Platí pro: MODEL 171 with ENGINE 113, 272

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 2 Podvozek › 43 Vzduchotlaková část brzd a přídavné brzdy › 43.10 Pneumatický posilovač brzd — Řada 171

EinPAS 21 Brzdy/podtlakový systém/vzduchotlaké zařízení › 21.15 Provozní brzda/podtlakový systém › 21.15.13 Potrubí/hadice/ventil — Řada 171

Platí také pro motory/převodovky: 113 ***, 272 ***

AR43.10-P-0355VA

Remove/install brake booster vacuum line

25.10.10

MODEL 171 with ENGINE 113, 272

Remove/install brake booster vacuum line

P43.10-2037-07

Shown on model 171.456

1 Check valve

5 Resonance intake manifold

4a Retaining ring

A7/7 BAS brake booster

2 Vacuum line

3 Rubber grommet

4 Connection fitting

Modification notes

1.9.10

"Perform brake test on test bench" reference changed

Test sequence augmented/revised

Remove/install

1

Eliminate vacuum in BAS brake booster (A7/7)

To do this, press the brake pedal several times with the engine switched off.

Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

2

Open engine hood and raise to vertical position

AR88.40-P-1000V

3

Remove air filter housing

Model 171.454/ 456/ 458

AR09.10-P-1150VA

Model 171.473

AR09.10-P-1150AC

4

Pull check valve (1) with vacuum line (2) out of rubber grommet (3) of BAS brake booster (A7/7).

Installation: Install new rubber grommet (3).

5

Detach vacuum line (2) from connection fitting (4) of resonance intake manifold (5)

To do this, move red circlip (4a) so it touches connection fitting (4) and hold in this position. Then pull vacuum line (2) out of connection fitting (4).

6

Remove the vacuum line (2)

7

Install in the reverse order

Danger!

Risk of death caused by limbs being caught or crushed by rotating parts when performing tests on the brake test stand

Never leave the vehicle unattended on the rollers except in an emergency. Ensure that no one is under the vehicle or near rotating parts during testing. In case of emergency, use the EMERGENCY STOP switch to shut down test stand.

AS42.00-Z-0001-01A

8

Carry out brake test on the test stand

AP42.00-P-4290BA

Odkazované dokumenty