Removal and installation of propeller shaft intermediate bearing and replacement of grooved ball bearing

AR41.10-P-0100DA

29.7.94

MODEL 129, 140, 170, 202, 208, 210

Removal and installation of propeller shaft intermediate bearing and replacement
of grooved ball bearing

P41.40-0201-06

1 Front propeller shaft with clamp connection

1a Front propeller shaft with slide connection

2 Rear propeller shaft

3 Propeller shaft clamping nut

4/4a Rubber boot (optional)

6 Front protective cap (shaft side)

6a Rear protective cap (fork side)

7 Rubber mount, models 129, 140, 202 and 208

7a Rubber mount, model 210

8 Grooved ball bearing

 	Removal, installation
1	Remove propeller shaft	Model 129	AR41.10-P-0050A
		Model 140	AR41.10-P-0050DA
		Model 202, 170, 208	AR41.10-P-0050EA
		Model 210	AR41.10-P-0050B
2	Separate front (1, 1a) and rear propeller shaft (2) at clamp connection or slide connection	 Installation: Assemble propeller shaft.	AR41.10-P-0050-05DA
		Observe Technical modification 
	Clamp connection of propeller shaft	Model 129.066, 140.04/050/051	BT41.10-P-9110-01DA
	Universal joint on rear propeller shaft	Model 140.050/051	BT41.10-P-9111-02DA
3	Pull rubber boot (4, 4a) off joint fork	Installation: Replace damaged rubber boot and ensure correct fit.
4	Pull off rubber mount (7, 7a) with grooved ball bearing (8) and front protective cap (6)		AR41.10-P-0100-01DA
		 Installation: Press rubber mount with grooved ball bearing onto the joint fork.	AR41.10-P-0100-05DA
		Fit new protective cap on grooved ball bearing. Models 129, 140 and 202 as of 6/95 are no longer fitted with a protective cap.	AR41.10-P-0100-04DA
		Models 170, 208, 210 are no protective cap
		Observe Technical modification
	Propeller shaft intermediate bearing	Models 129.066/067/076, 140.04/05/07/13	BT41.10-P-9208-01DA
5	Remove rear protective cap (6a)	Installation: Replace protective cap if damaged.
6	Press grooved ball bearing out of rubber mount	 Models 129, 140,170.445/447, 202.024/025/026/028/029/082/085/086/ 089/128/133/188/193, 208.345/347/365/370/445/447/465/470, 210.006/015/017/020/025/045/053/055/ 06/07, 210.08/206/215/217/225/245/26/27/28/ 606/617/663	*116589094300
		 Models 170.435, 202.01/020/022/023/078/080/083, 202.120/121/122/125/180/182, 208.335/435, 210.003/004/010/035/037/210/235/237, 210.610	*201589094300
		 Installation: Press grooved ball bearing into rubber mount.	AR41.10-P-0100-02DA
7	Check rubber mount and grooved ball bearing for wear	Replace parts if necessary.
8	Install in reverse sequence.