Model | 368.0 with transmission 712.622/631 |
Model | 368.1 with engine 904.9, 906.9, 924.9, 926.9 |
Model | 382 with engine 906.918/933/974/975/977/994, 926.910/926/988 |
Model | 384.063 with body 382.845 |
Model | 384.2/3 with engine 904.977/978, 924.929 |
Model | 685.282/284/289/290 with engine 924.9 |
Model | 688 with engine 904.924/957 |
1 | Hydraulic sender cylinder |
2 | Cylinder activation rod |
3 | Clutch pedal |
4 | Pedal stop |
5 | Stop bracket |
6 | Rod pivot shaft |
7 | Rod adjustment eccentric bushing |
B | Rod play |
B29.10-0002-06
1 | Adjust the length of the auxiliary pedal spring | Adjust length of auxiliary spring of pedal | |
Adjust on the bench the length of the pedal helper spring. It is also possible to adjust with the bracket mounted on the vehicle. | |||
The adjustment of the pedal rod clearance must be carried out with the bracket mounted on the vehicle, however, before final adjustment, two operations are necessary which, if carried out later, change the adjustment. Carry out in order. | |||
2 | Bleed the clutch actuation system before final adjustment of the sender cylinder rod | Bleed clutch operating system | |
Bleed clutch operating system. | |||
Bleed clutch operating system. | |||
It must be done after adjusting the length of the spring. | |||
3 | Hold the rod adjusting eccentric bushing (7) with a suitable wrench and slightly loosen the rod pivot shaft (6) | ||
4 | Hold the rod pivot shaft (6) and rotate the rod adjustment eccentric bushing (7) until the rod clearance (B) of the cylinder actuation rod (2) is obtained in the sender hydraulic cylinder (1). At this point, fix the rod pivot shaft (6) | The clearance now existing between the rod and the cylinder should be minimal and can be seen by moving the cylinder's actuation rod (2) with the fingertips on both sides. | |
.Freeplay (B) of the cluthc master cylinder | |||
5 | Operate the pedal several times and check the rod clearance (B) between the cylinder actuation rod (2) and the sender hydraulic cylinder (1) | The clutch pedal (3), once adjusted, when activated manually, should show a slight gap between the pedal and the pedal stop (4), which will correspond approximately to 0.30mm. | |
.Freeplay (B) of the cluthc master cylinder | |||
6 | Fit the protection belows |