Remove/install oil lines of oil cooling for automatic transmission

AR27.55-P-0600TS

Remove/install oil lines of oil cooling for automatic transmission

18.5.09

12.4.06

Bolt, oil cooler line to engine oil pan

*BA27.55-P-1003-01D



Notes on self-locking nuts and bolts

AH00.00-N-0001-01A



Before starting work the area around the oil cooler lines (1, 2) must be thoroughly cleaned in the area around the separation points. Even the smallest dirt particles, introduced into the hydraulic components, can lead to malfunctions and a total failure of the transmission

1

Move selector lever into position "N"

2

Release parking brake

3

Switch ignition off, remove ignition key (transmitter key)

 Vehicles with Keyless-Go code 889: Press the Keyless-Go start and stop button repeatedly until the ignition is switched off.

Remove the Keyless Go transmitter card or transmitter key from the vehicle and store beyond the reach of the transmitter (min.
2 m).

4

Unclip safety clamps (7, 8) of the left and right oil cooler line (1, 2) on the radiator (3)

 Do not pull the oil cooler lines (1, 2) out of the radiator (3).

5

Remove bottom engine compartment paneling

AR61.20-P-1105T

6

Pull oil cooler lines (1, 2) out of the radiator (3)

 In order to avoid damage and leakage, do not kink or bend oil cooler lines (1, 2).

 Collect escaping transmission oil in a suitable container and seal off line connections with  plugs.



*129589009100

 Installation: replace O-rings.

7

Remove bolts (4, 9) and pull left and right oil cooler line (1, 2) out of the transmission

 In order to avoid damage and leakage, do not kink or bend oil cooler lines (1, 2).

AR27.10-P-0502-01TS

 Collect escaping transmission oil in a suitable container and seal off line connections with  plugs.

Left oil cooler line

8

Mount engine support frame and raise engine

 Raise engine until the front engine mounts are completely relieved of load.

AR33.10-P-0100-01T

9

Detach right and left engine mount from front axle carrier

Engine 273

AR22.10-P-1260TS

Engine 272

AR22.10-P-1260TX

10

Detach retaining clamps (10, 11, 12) from engine oil pan and remove the left oil cooler line (1)

 To prevent damage and leaks, do not bend or kink left oil line (1).

 The left oil cooler line is removed via the intermediate space arising between the engine mount and front axle carrier.



*BA27.55-P-1003-01D

Right oil cooler line

11

Detach retaining clamp (5, 6) from the engine oil pan and remove the right oil cooler line (2)

 To prevent damage and leaks, do not bend or kink right oil cooler line (2).



*BA27.55-P-1003-01D

12

Install in the reverse order

13

Check transmission oil level and correct if necessary

 Always observe work procedure and Specifications for Operating Fluids, otherwise transmission will be damaged.

AR27.00-P-0270W

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

14

Carry out engine test run, checking the transmission for function and oil leaks

Number

Designation

Trans-mission
722.9

BA27.55-P-1003-01D

Bolt, oil cooler line to engine oil pan

Nm

12