Platí pro: TRANSMISSION 716.643 in MODEL 901.6##, 902.6##, 903.6##, 904.6## ## up to 159192 TRANSMISSION 716.601 in MODEL 203.004, 210.007 TRANSMISSION 716.620 in MODEL 203.035, 210.035 /235 TRANSMISSION 716.621 in MODEL 210.061 /261 TRANSMISSION 716.622 in MODEL 170.444 /449, 203.045, 208.344 /444, 210.048 /248 TRANSMISSION 716.623 in MODEL 203.061, 209.3 /4, 210.062 /063 /262 /263 TRANSMISSION 716.640 in MODEL 203.006, 210.006 /206 TRANSMISSION 716.641 in MODEL 203.016, 210.016 /216 TRANSMISSION 716.660
Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.
Platí také pro motory/převodovky: 716 601, 716 620, 716 621, 716 622, 716 623, 716 628, 716 640, 716 641, 716 643, 716 644, 716 660, 716 662, 716 663
AR26.40-D-2002-01A
Disassemble transmission housing
711 589 04 15 00
Drift
Retainer wrench
716 589 00 09 00
Commercially available tools
Number
Designation
WH58.30-Z-1008-02A
Circlip pliers for external circlip
D26.40-1120-01
1 Remove countershaft seal cover (1).
2 Remove radial shaft seal for input shaft (2).
To do this, pierce the two opposite bulges (arrows).
3 Use pliers to remove circlip (3).
4 Unscrew bolt (4).
Hold input shaft with retainer wrench.
D26.40-1102-01
5 Turn the transmission until it is horizontal and then unscrew the bolts (5).
6 Place the two locking bolts (arrows, roughly 60 mm in length) in the illustrated positions and screw them in a couple of threads.
D26.40-1103-01
D26.40-1104-01
7 Turn transmission to vertical position (rear section of transmission housing at the bottom) and drive out countershaft with plastic mallet and drift.
8 Turn transmission to horizontal position and unscrew locking bolts.
9 Remove the rear section of the transmission housing (6) together with the transmission shafts (7).
D26.40-1138-01
10 Press input shaft (8) out of front section of transmission housing.
