Remove/install bottom part of charge air distribution pipe

AR09.41-D-1313A

25.6.99

ENGINE 611.981 /987 in MODELS 901.6, 902.6, 903.6, 904.6

ENGINE 611.983 in MODEL 690.6

D09.20-0012-06

1 Bottom part of charge air distribution pipe

2 Engine wiring harness

3 Bracket

4 Screw

5 Gaskets

6 Screw

7 Screw

 	Remove, Install
1	Remove top section of charge air distribution pipe		AR09.41-D-1312A
2	Disconnect engine wiring harness on vehicle side		AR15.18-D-1000-02A
3	Remove bracket (3) at bottom part of charge air distribution pipe (1)
4	Detach fuel pressure sensor at bracket (3) and place to the side	Engine 611.983
5	Release fuel lines from the fixtures (arrows) at bottom part of charge air distribution pipe (1)	 Intake manifold with inlet port shutoff
		Remove/install oil-water heat exchanger	AR18.30-D-3481A
6	Detach bottom part of charge air distribution pipe (1) at cylinder head	 Run engine wiring harness through the opening at the bottom part of the charge air distribution pipe.
		 Installation: Check gaskets (5), install new gaskets if necessary.
			*BA09.41-N-1001-01D
7	Install in the reverse order
8	Code radio, set clock

Charge air pipe/charge air cooling

Number	Designation		Engine 611.981/ 983/ 987


BA09.41-N-1001-01D	Bolt of bottom part of charge air distribution pipe to cylinder head	NM	16