T07.12-0002-01
1 Inspection hole of timing case
2 Start of delivery marking
T07.12-0001-11
3 Screw plug of inspection hole
| Removing | ||
1 | Detach engine compartment encapsulation | ||
2 | Attach cranking device to inspection hole of timing case (1) | | |
3 | Take off service flap above engine and above transmission | ||
Setting | |||
4 | Crank engine in direction of rotation until start of delivery marking (2) on the flywheel is aligned with the edge of the inspection hole of the timing case (1) | ||
5 | Remove screw plug of inspection hole (3) at injection pump housing | Check in inspection hole whether pointer is pointing exactly to middle of mark in marked area. If the marked area is not visible, it must be assumed that cylinder 6 is at ignition TDC. Crank engine further in direction of rotation until start of delivery marking is again visible in inspection hole. If the mark in the marked area is not within the pointer, set start of delivery | |
6 | Set start of delivery at drive bevel gear | ||
| |||
| |||
| |||
| |||
| Installing | ||
7 | Take off cranking device at inspection hole of timing case (1) | ||
8 | Insert screw plug of inspection hole (3) at injection pump housing | | |
9 | Fit on service flap above engine and above transmission | ||
10 | Fit on engine compartment encapsulation |
Crankcase, timing case cover, end cover
Number | Designation | Engine 447 | Engine 489 | ||
BA01.40-N-1005-01H | Bolt of end cover to timing case | Nm | 40 | 40 | |
Injection pump, unit pump, high pressure pump
Number | Designation | Engine 447 | Engine 489 | ||
BA07.02-N-1001-01A | Bolt of drive gear to injection pump | Nm | 35 | 35 | |
IFI diesel injection system
Number | Designation | Engine 447, 489 | ||
BA07.12-N-1001-02B | Screw plug to injection pump housing | M18X1.5 | Nm | 80 |
BA07.12-N-1002-02B | Bolt of injection pump to crankcase | Nm | 50 | |
BA07.12-N-1003-02B | Bolt of angle bracket to injection pump | Nm | 80 | |
Cranking device
407 589 00 63 00