Vehicles without ASSYST maintenance computer
Normal operation
Maintenance according to mileage or service hours.
Severe operating conditions
In cases where the operating conditions are more severe than usual, the maintenance work should be performed at shorter intervals.
Examples of operation under severe conditions:
- Construction site mode without road traffic in very difficult terrain with a heavy load,
- Regular trips on unsurfaced roads,
- Extreme short-distance traffic.
Engine oil and filter change
Deviating change intervals apply depending on the quality of the fuel and use of the vehicle (see current maintenance booklet).
Maintenance intervals
|
Engine | 111, 611 Argentina | 111, 611 Latin America without Argentina | ||
Normal operation | Severe operating conditions | Normal mode | Severe operating mode | |
Oil service every | 22 500 KM 450 h | 11 250 KM 225 h | 15 000 KM 300 h | 7 500 KM 150 h |
Maintenance service every | 45 000 KM 900 h | 22 500 KM 450 h | 45 000 KM 900 h | 22 500 KM 450 h |
Vehicles with ASSYST maintenance monitor
ASSYST calculates the optimum maintenance time and informs you of this using its multifunction display. The remaining distance is displayed in km or the remaining driving time in days, depending on whether the km interval or the time interval is reached first.
-----------------------------------------------------------------------------------------
Additional jobs at the maintenance service or time-dependent maintenance jobs are not displayed via the multifunction display. These must be carried out additionally or separately at the relevant point in time.
After completion of the maintenance work reset maintenance computer.
-----------------------------------------------------------------------------------------
Maintenance information
The maintenance scope is given in the applicable maintenance sheet and the content of the maintenance work for the individual service items is given in the maintenance manual.
Additional work for maintenance service and time-dependent maintenance work are summarized at the end of the maintenance sheet. It should be agreed upon with the customer and ticked off in the header section on the first page of the maintenance sheet:
- Additional operations at every 2nd maintenance service
- Maintenance operations every 2 years
- Maintenance jobs every 3 years
- Maintenance operations every 10 years/300,000 km
The completion of the individual maintenance items should be documented on the maintenance sheet by making a cross in the boxes in front of the operation titles.
A cross should be entered in the boxes after the operation titles to identify items which were not OK when the vehicle was received.
Confirmation for this is provided by the person completing the work by entering his/her signature in the header section of the maintenance sheet.
Checking the oil level in the manual transmission and in the rear axle has been replaced by visual inspection of the major assemblies for leaks.
If there is visible oil loss, the cause must be determined in the usual way and eliminated (subject to a separate repair order).