Install new compressed air line connector

AR42.10-B-0950A

Install new compressed air line connector

09.03.2020

Model

368.0/1, 382.0/1, 384.0/2/3, 390.00/01/04/09, 634.0, 684.05/2, 685.4/5, 688.1/2, 979.2

Except for VOSS 230 and VOSS 232 connection

Model

384.0, 386.0/3, 388.0/3, 390.01, 660.0, 684.006/01/2/302, 685.4, 693, 695, 696, 958

Except for VOSS 230 and VOSS 232 connection

Model

384.0/1, 386.0/3

Except for VOSS 230 and VOSS 232 connection

Model

682.0/1/3, 693, 694, 695

Except for VOSS 230 and VOSS 232 connection

Model

688.1/2, 958, 979.0

Except for VOSS 230 and VOSS 232 connection

1

Compressed-air pipe

4

Cutting pliers

2

Connection

5

Locking pliers

3

Assembly pin



Remove

1

Depressurize the compressed-air system

Notes on compressed air connection systems

AH00.18-N-0001-01A

2

Cut the compressed-air pipe (1) and remove the connection

 The piping must be removed from the vehicle and reworked on the stand in a vise, the work must be cold made.

 Knife

*000589122800

3

Clean the bottom and exterior part of the pipe



Install

4

Fasten the compressed-air pipe (1) in the locking pliers (5)

 Fasten the pipe in such a way that the end stays out of the pliers enough to fit in the connection.

 Clamping pliers

*387589023700

5

Fasten the pliers with the piping in a vise.

6

Put the connection's end in the piping and beat until they fit completely

 During assemblage, do not use lubricants and/or instantaneous / anaerobic bonds. Before beating, check if the plastic protection is assembled, remove it only after the installation. For the "L" shaped connections, a plastic protection is not necessary, use a tool of the appropriate dimension.

 Knock-in piece

*387589036300

 Assembly tool

*055589006300